Find your own way, we recommend working from middle Peel the paper from the backing about a third at time, smooth with your hands as you go. Then line up your first length of wallpaper with this pencil line.Ģ & 3. Hold a plumb line on the mark and draw a vertical line down the wall. Tip: Make a pencil mark one wallpaper width along the wall near the ceiling. The lengths should be hung edge to edge without any overlapping. The lengths are numbered in the order in which they must be hung. Make sure you have all the lengths and that none of them are defective or damaged.Ģ–5. Lay the lengths flat, with the label facing upwards, in numerical order starting with length number 1. Start by dividing the lengths as indicated by the cutting symbols. We recommend at least 24hrs to be flat and climatized in the same room as intended for installation. Lay flat all your tiles as the wallpaper might have a curl memory from the roll. You should give your walls 4-6 weeks to fully cure completely. Have you freshly painted walls before application, preferably a light uniform colour if it differs significantly from your wallpaper as dark patterns / colours may show through. While cleaning your wall take the last opportunity to finally check: is this a smooth surface? Orange peel, knockdown or a rough wall will make the peel&stick wallpaper challenges to adhere to the wall, if the surface is not smooth we recommend the conventional non woven wallpaper with paste the wall glue. Allow the walls to dry for a minimum of 24 hours. Using a damp cloth or sponge, clean the surface with warm water and mild soap. Wait 24 hours to see the finished results Once all the panels have been hung, trim off any excess paper using a trim guide and a sharp knife. If there are any spots of paste on the front of the wallpaper, use a damp cloth or sponge to remove them, but avoid rubbing. Any small bubbles and folds will disappear once the wall mural has dried. Use your hands or a wallpaper brush, starting from the middle and smoothing out towards the edges. Smooth down the panels from the ceiling to floor Note: Avoid harsh folds as this may cause cracks in the print.ĥ. Be careful to match up the pattern with the next panel, and avoid getting wallpaper paste on the front of the mural as this will show when it dries. Take care to press the panels together firmly at the seams – use a seam roller for the best results. Apply the paste approximately one panel width in advance. It’s important to cover the whole area with paste – an unpasted spot will create a blister in the wall mural. Make sure the markings are faint so they don’t show through the wall mural. Use the markings as a guide to hang the rst panel. It is a good idea to draw vertical markings one panel width (50 cm) in from the corner usingĪ spirit level, a measuring tool and a pencil. It is vital that the first panel is hung straight. The panels are numbered at the top in the order they should be hung. If you are using ready-mixed wallpaper paste, use a paste for non-woven wallpaper or one for woven wallpaper with <20% dry content.īefore hanging, make sure no panels are missing and none have any defects or damage. If you do add more, the wallpaper may not fix properly. The paste should be nice and thick, so don’t use more than 4 litres (1 US gallon) of water when mixing. Leave the paste to stand for 5 minutes and stir again. You should also prime the surface if it has bright colours that could show through the wall mural.įill a clean bucket with 4 litres (1 US gallon) of lukewarm water and slowly add the paste powder while stirring briskly. If you hang our premium murals on a dense surface that does not absorb moisture, it may take several days for the paste to dry, as our premium papers are not as breathable as our standard ones. Porous surfaces include skimmed walls, walls with old wallpaper, particle board or similar. If the surface is porous, please apply a primer/mist coat or prepaste before papering. Clean the surface and apply filler where necessary. Remove any old paint or wallpaper that is coming off.

Make sure the surface is smooth and clean

Rose gold black glitter wallpaper